Premium GPS Tracker Installation Guide
IMPORTANT – THIS DEVICE IS ONLY TO BE INSTALLED BY SUITABLY QUALIFIED INSTALLERS
The tracking device must only be mounted inside of the vehicle, it cannot be installed in the engine bay or in any area of exposure to direct external conditions. The device must be hidden (for example, under the upholstery), as well as protected from moisture exposure. The device must be fastened in a stable position to avoid random twitches and displacements (suspension on cables is strictly prohibited). The device unit must be mounted horizontally. Precise orientation is of particular importance to flawless operation of the system, since the device is equipped with acceleration sensors recording the data which directly affects the results obtained.
Premium GPS Tracker Installation Guide
Black – Earth/chassis
Red – Perm Live 12/24volts
Grey/Black – ACC Live
Purple/Black – Output to relay (negative trigger to 5 pin relay)
Technical Specifications
Interfaces
1-Wire
Inputs
4x digital (frequency, impulse counter, ON/OFF modes)
2x analogue, 11 bit, 0-36V
Outputs
2x digital, (-)
Power supply
8 – 36V
Protection from impulses up to 120V
Consumption at 12V: active: <50mA, sleep: <8 mA
Registration of power cut-off to device event log
Internal battery 700 mAh (optional)
Internal memory
4 МB, up to 150.000 entries
Accelerometer
3 axis digital accelerometer
Operational temperature range
from -40 to +85 C°
Dimensions
68x91x19 mm
Weight
Tracker – 62 g, set – 141 g
GSM
Internal antenna
GSM/GPRS class
10 (up to 85,6 kbit), class B
Detection of GSM jamming
GPS / GLONASS
Internal antenna
Sensitivity
-162 dBm
Acquisition
Cold <30 s, hot 1 s. A-GPS support

Enabling the IMMOBILISER from the desktop.
Click on the information icon next to the tracker in the object list as shown.

Click on the toggle switch in the information bar at the bottom of the screen.

Enabling the IMMOBILISER from the APP.
Click on the information icon then scroll down to outputs box where you can toggle the outputs. Output 1 is the default output which controls the immobilise relay as per the wiring diagram.

Driver Behaviour (Harsh Driving)
Adjust the sensitivity of the driver behaviour monitor in the device settings panel.
